Mysteries :
The Official GrahamHancock.com forums

For serious discussion of the controversies, approaches and enigmas surrounding the origins and development of the human species and of human civilization. (NB: for more ‘out there’ posts we point you in the direction of the ‘Paranormal & Supernatural’ Message Board).

I think this diagram is self explanatory .

Shssss

Tip toes back in

or

Time to hang the calculator up.

Just updating

Thought i would dispel any suggestions that the number

Also another way to find

And of course most know of that Metric figure for the speed of light and G1's Apex map location, that can be read as

If

DPP

Edit, correcting mistakes

Edited 12 time(s). Last edit at 24-Feb-19 15:35 by DUNE.

Shssss

Tip toes back in

**miles, or Earth's Equatorial circumference***9.0676 x 8.472 x 4.1505 / 22/7 = 101.451" read as ft x 360 x 60 x 60 / 5280 = 24901.6*or

**101.451" / 12 = 8.45425 ft x 15552000 / 5280 = 24901.6 miles**Time to hang the calculator up.

Just updating

**The Speed of Light**perimeter calculation via the**Square root of Three figure of 1.7320508**Thought i would dispel any suggestions that the number

**510000**is an arbitrary figure plucked out of thin air in that signature sum of mine , as you can see its found by combining the four slopes of G1 and G3 then the four Ridges of G2, then multiplying by 3.1416 =**510000**Also another way to find

**The Speed Of Light**is to multiply the heights of the three pyramids and divide by**450**And of course most know of that Metric figure for the speed of light and G1's Apex map location, that can be read as

**299792458**If

**Hemiunu**was the architect of G1 and the whole of Giza , then one can only assume he got the plans from an outside source, who might that have been ?DPP

Edit, correcting mistakes

The Speed of Light = 186,282,398 mps / 510000 = 365.259604

G1 x G2 x G3 / 12 / 5280 / 1.73206803 = 186,282,398

G1 x G2 x G3 / 12 / 5280 / 1.73206803 = 186,282,398

Edited 12 time(s). Last edit at 24-Feb-19 15:35 by DUNE.

Sorry, only registered users may post in this forum.